Today’s tasks included finalising the oil tank pipe run, prototyping the water radiator return hose, installing the fuel pressure sensor Tee and the ‘stand-offs’ to ensure adjacent pipes don’t rub against each other.
The water return hose requires a 22mm elbow to enable it to fit the installation. I’ve used an ordinary copper solder ring plumbing elbow. The solder ring gives a raised ring that allows the clamp to hold the fitting securely.
After running the hoses most need stand offs to make sure they don’t rub on adjacent pipes
A view from the top showing the fuel pressure switch just behind the gearbox and the top oil hose on the left.
G-MLSY 